Submersible pump Evak Hippo 50S

EVAK HIPPO submersible pumps with 230V single-phase motor and three-phase 400V for 1.5kW and more pumps, versatile, with a SuperVortex type impeller with a free passage Ø50, Ø65, Ø80 providing the possibility of pumping sewage and sludge.

The impeller used in the HIPPO pump is a unique solution - the result of research and practical experience of the manufacturer - a special blade design optimizing the efficiency of the pump. The pump is even more resistant to clogging, thanks to the accelerated waste water return from the rotor area.

As standard, made with double mechanical seal in oil bath and equipped with cable type H07RN-F - completely tight, epoxy choking cable.

Automatic thermal protection built into the pump.

Technical data:
-SuperXVortex type open-ended impeller, dynamically balanced, thanks to which the load on the bearings and shaft is reduced to a minimu
-Double mechanical seal made of silicon carbide on the side of the pumped medium working in an oil bath for increased resistance to abrasion
-Automatic thermal protection
-Compact design, easy operation and maintenance
-Designed for continuous operation (S1, 230V, IP 68, 50Hz, 2850 RPM)
-Completely sealed cable choking
-Also available in version with float switch
-Handle: PA6
-The outer casing of the engine: PA66
-Lower pump housing: Gray cast iron
-Motor shaft and rotor: Stainless steel 1.4006 (AISI 410)
-Housing: Stainless steel 1.4301 (AISI 304)
-Bolts and nuts: Stainless steel 1.4301 (AISI 304)
-Engine cover: PA 66 (HIPPO 75,100) / gray cast iron (HIPPO 150,200)
-Impeller: gray cast iron
-Oil chamber: gray cast iron
-Seals: NBR oil-resistant rubber
-Mechanical seal: double sealing - external SiC / SiC, internal Ca / Ce
-Bearings: maintenance-free, lubricated for life
-Cable: H07RNF0 rubber
-Oil in the oil chamber: ISO VG32
-Maximum liquid temperature: 40 ° C
-Cable length: 10 m
-The size of the pollutants being pumped: 50, 65, 80 mm
-Thermal protection built-in
-GW discharge connector "